Step 6: Trim and glue the answer key ( Layers of Earth & Atmosphere Labels) to the back of the foam board. A glue gun works, too.) The above photos show the craft foam layers-of-earth, but the photo below shows it with construction paper. Again, I used tacky glue for the permanent bond and a couple of dots of superglue for a temporary bond until the tacky glue holds. (Shown in sub-step #8 in the above image. Step 5: Fold the construction paper layers-of-earth model in half and then glue in place. (I used tacky glue for the permanent bond and a couple of dots of superglue for a temporary bond until the tacky glue holds.) Also stack and glue 4 semicircles (the green semicircles in pic #7 above) to the foam board for proper alignment when you glue the construction paper layers-of-earth model in place. Step 4: If you have not already done so, cut the 3″ Styrofoam “Squeeze” Globe (which is not a stress ball I’m not sure why they call them squeeze globes, actually) into fourths and adhere one fourth of the globe to the top of the troposphere layer as shown in sub-step #5 in the above image. This entire step is shown below as sub-steps 1-6. Use the exosphere template to trace a dotted line for the exosphere using a chalk marker or white paint pen. Using glue sticks or self-stick foam, adhere the Thermosphere layer to the black foam board and stack/glue on top the Mesosphere, Stratosphere, and Troposphere. Step 3: Build an atmosphere model with craft foam semicircles. To eliminate cutting the smallest circles (inner core), I opted to use Avery Color-Coding labels for the inner core.Īfter my first attempt using craft foam for the layers of the earth, I decided to switch to using construction paper. Glue together: Crust, Mantle, Outer Core, Inner Core. Step 2: Make a construction paper model of the earth. (You’ll need a total of 4 concentric circles for the layers of the earth and 5 larger concentric semi-circles for the layers of the atmosphere, plus two additional circles the size of the crust template to cut in half and stack as mentioned in Step 4.) Step 1: Cut out a bunch of circles and half-circles of varying sizes using a Cricut or other type of circle cutter, or you can use this Earth Model Template along with a handy pair of scissors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |